Dashboard Lights

[DrPrepper]

I need to replace a few "dead bulbs" on my dash layout on a 2006 voyager, there are two areas where I have no light - one being the dashboard light control panel (off to the right hand side of the dash) and the other being the centre console display for heated seats etc. in both area some work but not all.

I know how to get at the bulbs....but dont know where to get any from!!

Any ideas???

Many thanks.

[ryden]

Hi Dr,

 

I presume you've tried the common places - Chrysler ( garages) , auto factors and ebay/ amazon?

 

Also I've inserted a table of all interior bulbs, in case it's needed.

 

Edited August 27, 2017 by ryden

[mikebh8]

Just make sure is the same wattage, my godfather was keep replacing them from halfords without realising he was getting .2w instead of 2w. If you can still read the numerics on it is ideal to stick with same values as sometimes the numberplate will bring up wrong items for same car.... I did buy a petrol filter once even though the car didn't have one.

 

Hope it helps.

[luminova11]

Ryden,

 

Any cance of posting this table again please, the link has expired

 

Thanks

Hi Dr,

 

I presume you've tried the common places - Chrysler ( garages) , auto factors and ebay/ amazon?

 

Also I've inserted a table of all interior bulbs, in case it's needed.

 

[legonsuk]

If they are like my 2004 grand the centre console display for heated seats etc are all soldered to the circuit board had all my bulbs go on the centre console and light switch so soldered green LED bulbs in looks the nuts but what a job you have to take the circuit board out . 

[dmal4ev]

Hi there, a month ago I replaced all bulbs on the heated seats and rear wiper buttons. I used led and they are still working fine. This is what I bought

https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F163856940762

Cheers

Dan

[Millymoo]

Hi, can anyone repost the table of interior bulbs. My bulbs are missing from the centre console so I have no idea what bulbs they are! Any help is much appreciated.

I have a 54 Chrysler Grand Voyager

[legonsuk]

Are you on about the heater control panel and the heated seats and hazard light panel if so they are soldered to the circuit board .

[Vanman]

Hi

I’m new on the forum and interested in the led replacement I have only one lamp left on in the heater control

Do the less solder In as a straight Replacement do I need to check polarity

Thanks

[andyb2000]

Hi,

Yes polarity matters for LED so best to use a multimeter to test them first to get it the right way round.

It's a bit old now but I did a post on my website about LED replacements:

http://www.thebmwz3.co.uk/2018/02/chrysler-dash-bulb-replacements.html

It might help you a little.

[Vanman]

I’ve ordered both tungsten and led in white. Will report back on progress when they arrive

Thanks

[Vanman]

Fitted the tungsten lamps They work fine. I will keep the LEDs in reserve when they arrive from China