crispinchurch

looked at mine and yes all lite up the screw is in the sun glasses pull down unit taken from manual REMOVAL (1) Disconnect and isolate the battery negative cable. (2) Remove the overhead console retaining screw, located in the front of console. (3) Grasp the sides of the overhead console and pull straight down evenly to disengage the two snap clips at the rear of the unit. (4) Lower the overhead console far enough to access the wire harness connectors. (5) Disconnect the EVIC, CMTC or CT electronic module and the reading/courtesy lamps electrical connector. (6) Remove the overhead console from the vehicle.

its on your V5

if its anything like AC and wipers switches then they are soldered on to the board and i have not found a replacement yet they are not a replaceable bulb and not led either are you sure they are lite when lights on i cant say i ever notice them lite up

update on xmas light bulbs didnt last long LOL

check the wires in the sliding doors take them out off the chain links and put a test meter on each wire in turn and bend the wires all along and see which ones broken

did you get a warranty with the car claim off that or go back wear you brought and see if they would do anything if it was a earth that went try just changing that one wire if it didnt melt any others

euro car parts and ebay is good for parts

just had my ac panel apart there 5 leds / bulbs only 1 was working leds blown when replaced so i had small xmas lights bulbs ended up 2 in series in each place and work well at moment

i have just done lights on my ac panel there 5 i think small bulbs soldered on look like leds but not so sure they get just under 3 volts i tried one led and it blows so next tried 2 small xmas tree bulbs in series which works fine just see how long it works for i had just one working

mine always done that on all 3 i had

what did you find ?

i got top of range in its day and that too have no bulbs in the light switches and the door switches only have green dot and center controls are the same not all switches lights up today i had the switches for heated seats and rear wipe apart and that got led`s some was blown ? you cant hurt it to try bulbs in it as for grab handles its very easy to feed wire in behind the roof lining if you dont find them

most dont light up if you take off the whole front grill take out the two plugs /cover at top 2 screws and at bottom there a bit of trim in middle pull 2 screws there then pull the lot of the wooden side trims come with it 3 plugs pull color tab towards wire then pull plug out unscrew the ac panel pries off back and and unclip pc board see if there is lights there if so test the plug see if you got voltage when main light on replace the bulbs reversing light sorry dont know

as above photo the long switch that tilts the seat also pushes forward and backward and if you got on driver door a 1 S 2 button when you got radio set and seat and mirrors right with key on press S until it beeps then press 1 or 2 until beep and all will be pre program you can even set up each key for different people

stem get one on ebay plug in door check wires in door to see if your getting voltage if so new door lock pusher sorry erg cant help with

time to worry is when they are lit :-) check plugs on back

google and down load a copy try here http://www.wjjeeps.com/nav.htm#INTRO1

Using a functional key fob transmitter, unlock the vehicle and disarm the Vehicle Theft Security System. Insert ignition key into the ignition switch. Turn the ignition switch to RUN position without starting engine. Using a functional key fob transmitter, press and hold the UNLOCK button for a minimum 4 seconds (maximum 10 seconds). While holding UNLOCK button, and before 10 seconds passes, press and release the PANIC button. A single chime will sound to verify that the Remote Keyless Entry (RKE ) module is set to receive the new Vehicle Access Code(s). Within 30 seconds of the chime, press any button on each new key fob transmitter. After 30 seconds or when ignition switch is turned OFF , theRKE module will end the programming mode. A single chime will sound to verify that the RKE module will no longer receive additional Vehicle Access Code(s). When Vehicle Access Code(s) programming is complete, turn Ignition Switch to the OFF position and verify RKE system operation using each key fob. sounds like you got broken wires in going to the doors the ones that are in a chain type under the door step solder in a new piece

try a wire from - battery and put it on metal of lights it gets brighter fit new earth or go to 100 watt bulbs

dvd turn radio on put a dvd in and on mine the dvd play straight away on car speakers pressing mode switch lets me choose radio or cd ect and dvd in head phones in 2005 i had dev and that was 23mpg on a auto 05 plate i now got 2003 plate 3.3l auto running on LPG getting .16p a mile on LPG and .29p on petrol

when you close the sliding door does a motor start and pulls the door inwards does the boot work with the switches above interior mirror there fuses in the bonnet and try pull out fuse od? front right for 10 minutes and replace try doors buttons inside

http://www.eurocarparts.com/ecp been very good on prices and ebay

update found out the plug is a playstation 2 where the other end goes unknown as its not the dvd screen as for the 240volt dont know where the inverter is but it can stay never know it mite come in handy

there these two plugs under the front passenger seat the mains radio type plug has 240volts ac to it when key on the other unknown what its for ?

how did you get on with key fobs surprise no one answered on reprogramming the fobs