Leaderboard

Depending on how much you value the vehicle you could try drilling out the threaded section of the camshaft and helicoil it -WARNING may destroy the engine if not accurately done. otherwise; REMOVAL (1) Remove cylinder head cover (2) Remove camshaft position sensor and camshaft target magnet (3) Remove timing belt (4) Remove camshaft sprockets and timing belt rear cover (5) Bearing caps are identified for location. Remove the outside bearing caps first (6) Loosen the camshaft bearing cap attaching fasteners CAUTION: Camshafts are not interchangeable. The intake cam number 6 thrust bearing face spacing is wider. (7) Identify the camshafts before removing from the head. The camshafts are not interchangeable. (8) Remove camshafts from cylinder head. INSTALLATION CAUTION: Ensure that NONE of the pistons are at top dead center when installing the camshafts. (1) Lubricate all camshaft bearing journals, rocker arms and camshaft lobes. (2) Install all rocker arms in original positions, if reused. (3) Position camshafts on cylinder head bearing journals. Install right and left camshaft bearing caps No. 2 – 5 and right No. 6. Tighten M6 fasteners to 12 N·m (105 in. lbs.) in sequence shown in (Fig. 28). (4) Apply Mopart Gasket Maker to No. 1 and No. 6 bearing caps (Fig. 29). Install bearing caps and tighten M8 fasteners to 28 N·m (250 in. lbs.). NOTE: Bearing end caps must be installed before seals can be installed. (5) Install camshaft oil seals (Refer to 9 - ENGINE/CYLINDER HEAD/CAMSHAFT OIL SEAL(S) - INSTALLATION). (6) Install camshaft target magnet and camshaft position sensor. (7) Install cylinder head cover (Refer to 9 -ENGINE/CYLINDER HEAD/CYLINDER HEAD COVER - INSTALLATION). (8) Install timing belt rear cover and camshaft sprockets (Refer to 9 - ENGINE/VALVE TIMING/ TIMING BELT COVER(S) - INSTALLATION). (9) Install timing belt (Refer to 9 - ENGINE/ VALVE TIMING/TIMING BELT AND SPROCKETS - INSTALLATION).CYLINDER HEAD COVER (From the workpoo manual - sorry images are impossible to load due to stupid size restriction imposed on the forum

HIya.. yup seems everyone (if there are more than 1) have gone AWOL... spamming, well at least the witch doctors still haunt the site.

I agree pal, but I'm not sure if the site moderators / head guys are around much if at all. I can only go off the spamming that went on for a while and didn't get erased from the forum.